. After a construction period of less than 48 months,
Production of the first customer vehicles will begin as scheduled on 9 September 2019. Assembly will take place in a “factory of the future” – flexible, networked and using 4.0 production technology. It is a further step towards the “Zero Impact Factory” with no negative environmental impact: production of the
The construction project included several individual subprojects, each itself with considerable scope. The result was a body shop, a paint shop, a plant for the production of electric motors and components, a vehicle assembly hall and the connecting transport technology. A total of 35,000 tonnes of steel were used for the new production facility – as much as for 140,000
Start of construction at the end of 2015
The positive response to the motor show presentation of the
Preparation of the construction work alone required 21 individual preliminary projects and more than 5,000 employee relocations. This also included the excavation pit for the multi-storey assembly building located on a slope: since its height is limited to 38 metres so as not to impair the flow of fresh air to Stuttgart city centre from the north, the pit is 25 metres deep. 240,000 cubic meters of earth were moved for this purpose.
A new factory inside a factory
“We’ve built a factory inside a factory – in the middle of the city and close to our neighbours, in the most confined of spaces, in the shortest possible time and without disrupting the existing sports car production facility running at full capacity. Now the factory has been completed on schedule and without any major setbacks,” says Albrecht Reimold. “This was possible due to meticulous planning and an excellent team.” A total of 130 companies and suppliers were part of that team. One of the logistical masterpieces was coordinating the construction site traffic without impairing the significant regular flow at the plant. “Close dialogue with our neighbours was also crucial,” says Reimold. “We kept them fully up-to-date on developments throughout the entire course of the project.”
Some more figures: 10,000 construction site passes were issued, 530 construction site containers and three kilometres of site fencing were erected, and 35 kilometres of site power cables were laid, including power for the 1,000 linear luminaires distributed throughout the construction sites. Four kilometres of new road were also built within the plant.
Further information, film and photo material in the
© 2019 Dr. Ing. h.c. F.
^ The published electricity consumption (kWh per 100 km), charging times (hours/minutes) and kilometre (km) range are estimates determined in accordance with the Worldwide Harmonized Light-Duty Vehicles Test Procedure (WLTP) – see www.porsche.com/wltp. The WLTP is the test procedure used in the European Union and does not apply in Australia, where the New European Driving Cycle (NEDC) remains the appropriate test standard under ADR 81/02. Actual figures will vary as they are dependent on many factors including driving style, road and traffic conditions, weather conditions, a vehicle’s features, equipment, accessories, condition, load and use. Extra features and accessories (attachments, tyre formats, etc.) can change relevant vehicle parameters such as weight, rolling resistance and aerodynamics can also affect the electricity consumption and performance values of a car. The published charging times are estimated using the vehicle’s charging equipment and European charging facilities, with the battery temperature under optimum conditions and the vehicle having an initial charge status of 5%. CO2 emissions can also be generated at the power source when vehicles are being charged, unless 100% renewable energy is used. As Australian models have not been tested in accordance with the NEDC procedure, the published figures do not apply in Australia and must not be relied upon in making a decision as to whether to purchase a vehicle. Please contact an Official
* The published fuel consumption and CO2 emissions figures are determined by